DP/CAN coupler layer 2

The DP/CAN coupler layer 2 of Systeme Helmholz GmbH allows you to connect any number of CAN nodes to the PROFIBUS DP.
The DP/CAN coupler layer 2 must be parameterized in the hardware configurator as a PROFIBUS node. The GSD files required for this purpose are supplied with the device.
The PROFIBUS side is configured as a DP slave. The interfaces meets EN 50170 and are electrically isolated. Baudrates of 9.6 kbps to 12 Mbps are automatically detected. The size of the input and output information is up to 320 Bytes.
The CAN bus interface meets ISO/DIN 11898-2 and is electrically isolated.
The DP/CAN coupler can send and receive any number of CAN messages. Messages can be defined with a fixed identifier, whose data are always visible in the PROFIBUS as an I/O image. Alternatively the DP/CAN coupler layer 2 can be equipped with a receive buffer for any number of CAN messages.

Features
• Up to 1 Mbps CAN baudrate
• Up to 12 Mbps PROFIBUS-DP
• Address setting via DP switch
• Simple configuration via GSD file
• Any protocols possible via layer 2
• CAN 2.0 A (11Bit)
• CAN 2.0 B (29 Bit)
• Timer for cyclic telegrams
• 3 Status LEDs

orderdata
Product	ordernumber	Purchase list
DP/CAN coupler layer 2	700-651-CAN01	save...
Show request-list
Downloads
Product	Manual	Software	History
Manual, DP/CAN coupler L2, V5	(333,2 KB)
DP/CAN coupler GSD file, L2 V2H 11 Bit from FW-version 1.28		(4,4 KB)
DP/CAN coupler GSD file, L2 V2B 29 Bit from FW-version 1.51		(4,4 KB)