CAN 300, communication module with DNV certification

The CAN 300 module of Systeme Helmholz GmbH permits connection of CAN stations with the programmable controller. It is for use in an S7-300* from Siemens.
The module can be slotted either into the central controller or into the expansion unit.
The CAN 300 modules support both CAN 2.0A (11 Bit) and CAN 2.0B (29 Bit) frames with a free selectable baudrate of 10 kBit/s to 1 MBit/s. The CAN 300 module can also be run as Layer 2, CANopen Master, and CANopen Slave.
The CAN 300 module contains the power managment functions „Power On“, „Stop -> Run“ and „Run-> Stop“. IDs relevant to the programmable controller can be prefiltered using a 5-level acceptance mask.
In CAN 300 modules 11 free settable timers are available. Each timer can trigger a free programmable CAN frame. In that way, it is simple to implement synchronous protocols commonly used in drive and servo control using the CAN 300 module.

Note
Information about the parameterization software CANParam and about the data handling blocks for the PLC you will find under CAN Software.

When first used, data handling blocks are required for the PLC.

The CAN 300 module is DNV (Det Norske Veritas) „peripherial equipment“ approved for increased application conditions.

*) S7-300 is a registered trademark of Siemens AG

orderdata
Product	ordernumber	Purchase list
CAN 300, communication module (DNV)	700-600-CAN81	save...
Programming cable, serial, PC to CAN 300 communication module	700-610-0VK11	save...
Show request-list
Downloads
Product	Manual	Software	History
Manual, CAN 300 communication module, V.17	(740,3 KB)
CANParam V.4.20 program		(7,2 MB)	(3 KB)
CAN 300 - DNV Data Sheet	(91,8 KB)
Firmware History			(561 B)